How to Turn Off Audio Technica Turntable


To find out how to turn off your Audio Technica turntable, first read the manual. You should be able to find this information in the manual, or you can always look it up on the internet. You can also use the help function provided by the manufacturer. However, you should be aware of the limitations and risks involved in using the turntable with a computer. The following are some ways to solve these issues.

, How to Turn Off Audio Technica Turntable

When using the Bluetooth feature of your turntable, you have to press and hold the button on the turntable for at least eight to ten seconds. A red and blue indicator light will appear, which means that the turntable is in Bluetooth mode. If this doesn’t happen, you can try turning off the Bluetooth function by holding the button for 30 seconds. It will flash solid red before returning to normal operation.

After turning off the Bluetooth feature of your turntable, you should remove the red ribbon on the front of the machine. Then, you should place a 3.5 mm stereo AUX cable between the turntable and the audio source. If you do not have a 3.5 mm stereo AUx cable, you can also connect the turntable to a separate speaker. This will let you play the recorded music directly.

If the Bluetooth pairing mode doesn’t work, you can always try connecting the turntable to another Bluetooth device. This is a great option if you want to play music from your phone while listening to the turntable. You can also use a 3.5 mm AUX cable to connect the audio device to the turntable. This will allow you to play music from your phone or other device without any interruptions.

Recommended Read:- Audio Technica AT95E Review 2021

When it is time to turn off your Bluetooth connection, make sure you remove your Bluetooth device. The AUX cable is located on the front left corner of the turntable. After pairing the device, you’ll see the blue and purple light flashing. The button will stay on for 30 seconds. After pairing, press the button again. It will remain active until the speaker is unplugged. If this doesn’t work, the AUX cable will not connect to the turntable.

Most of these devices have a “PHONO-LINE” selector switch. If you want to connect your turntable to another device that is compatible with your Bluetooth device, you should press the switch labeled “PHONO” for the Bluetooth connection. If you don’t have a switch for both modes, you should use the other type of input. It is best to pair your devices with one another using a jack that supports both types.

Before you turn off your Audio Technica turntable, make sure you have your pre-amp switched to the “LINE” position. This will allow the cartridge to be paired to your device. If the other way is set to “AUX high-level output,” it is also time to turn off your turntable. Then, you’ll be able to enjoy music on your new device. If you’re using a different preamp, you should adjust it according to the specifications of your particular unit.

Before you turn off your turntable, check to make sure it’s connected to Bluetooth devices. Some turntables have built-in Bluetooth modules, and if you want to connect it to other devices, you can use an adapter cable. In addition to Bluetooth connections, the AT-LP60(X)BT also supports a USB-CODEC. You can connect this turntable to your smart phone through the “AUX” setting on your smart phone.

Read Also:- How to Use Audio Technica Turntable

The power cord plug on your AT-LP60BT turntable needs to be plugged in. Then, the dust cover needs to be installed in the hinge slots of the turntable. The dust cover may be removed during play. After this, the power cord must be plugged into the wall. This is the proper way to turn off your Audio Technica turntable. If the tone arm is connected to the power cord, turn it on again.

Leave A Reply

Please enter your comment!
Please enter your name here

17 − thirteen =